AWS WeatherBug Bedienungsanleitung PDF herunterladen (Seite 5)

Digital Display Manual

temperature and relative humidity readings. Unshielded sensors yield inaccurate

results that are highly dependent upon the incident solar radiation.

Data generated by the rooftop sensors is converted from analog to digital form to

the rooftop remote unit is fed via cable to the Master Control Unit (MCU) located

indoors. The barometric pressure sensor is located inside the MCU. The data is

stored in non-volatile electronic memory. Historical data can be stored (logged)

at selectable intervals; 15 minutes, 30 minutes or 60 minutes (1 hour). There is

sufficient memory in the MCU to store data for up to 4 months at 1-hour intervals.

Stored data can be transmitted through three separate outputs for viewing and

analysis.

The first output on the back of the MCU is labeled “Display", which will be

described in this manual. The "Digital Display" receives real time data (every one

second) from the MCU and displays the data on several large, easy-to-read

digital LED's. The display is housed in an attractive oak case and contains

several features for viewing daily highs, lows and rates of change.

WeatherBug Display Specifications:

*WeatherBug Weather Station records wind speeds well in excess of 99 mph or 99 km/h, and will show

these higher values in the computer software.

For more information on sensor specifications, see “WeatherBug System Installation, Operations and

Maintenance Manual”

Wind Speed

0 - 99 mph* 1 mph

0 - 99 km/h* 1 km/h

Wind Direction

0-360 deg

(16 compass points)

23 deg

(1 point)

Temperature

-60F to +130F 1F

-51C to +54C 1 C

Barometric Pressure

17.5"Hg - 32.0"Hg 0.01" Hg

593 mbar - 1084 mbar 1 mbar

Relative Humidity (RH)*

5% to 100% 1.0%

* Dewpoint calculated

from Temp. and RH

Rainfall

unlimited .01"

.02 cm

1 2 3 4 5 6 7 8 9 10 ... 16 17

Keine Kommentare

AWS WeatherBug Bedienungsanleitung Seite 5